Pardon our dust! We're working on something amazing — check back soon!

How to Install

1. Unplug your Power House motor from the power source.
2. Loosen and remove the existing power cord.
3. Take the Power House Replacement Power Cord and run it through the 2-1/2" water intake hole at the bottom of the shroud.
4. Apply a small pea-sized amount of dielectric grease to the power cord connector.
5. Line up the pins and holes from the power cord and connector on the end bell, and then twist it on.
   Hand Tighten Only - Do Not Over Tighten - Do Not Use Tools
6. Pull out additional slack through the 2-1/2" water intake hole and secure it with a clip and screw one additional measure you can take is to secure the power cord to a bracket with a zip tie and then secure it with the clip and screw on the shroud to prevent the power cord from hitting the propeller.